Round wooden frame

Give your embroideries a beautiful showcase!

These frames are made from high-quality birch plywood by a team of women woodworkers. They are then stained using natural finishes (Natural Oil, White Stain, Walnut Stain, Black Stain, Unfinished).

This frame fits a standard 15 cm embroidery hoop with a screw. The frame will cover about 0.3 cm of your fabric.

——

Frame diameter: 21,5 cm
Frame thickness: 1,7 cm
Compatible with 15 cm embroidery hoops
Available colors: White / Natural / Caramel / Dark Walnut

——

Assembly instructions:

Your hoop will hold the fabric tension and fit directly into the back of the frame. No glue. No fasteners. No damage to your embroidery.

You will need:

• Your hoop with your embroidered piece
• Your frame
• The cardboard shims provided with your frame

6 quick steps to install your hoop:

1. Ensure your hoop fits well into the frame. Place it into the notch at the back of the frame. Additional space is provided to accommodate your hoop’s screw.

2. Look at your hoop/frame from the front and adjust the hoop slightly to center it. There is a bit of wiggle room to make these small adjustments.

3. While holding the hoop in position, place the frame on a table, face down.

4. Detach a few of the cardboard shims provided with your frame. They are stapled to the instruction card or label. If you have large gaps between your hoop and the frame, fold the cardboard pieces in half or thirds to thicken them. For smaller gaps, use the unfolded shims.

5. Hold the hoop in position (relative to the frame) with one hand while inserting the cardboard shims into the gaps between the hoop and the frame. Place them on opposite sides of the circle to stabilize the hoop's position.

6. After adding 2 to 4 shims, your hoop should be securely wedged! It's time to admire your work and hang it up!